The stove stopped blowing into the legs completely, only the forehead and only the interior. Previously, if a problem arose, the gearbox gurgled, knocked, hummed, we got by by removing the terminals, because after removing the terminals, the gearbox began to hum and knock, and it seemed that something was bothering it, BUT it was adjusted and all positions fell into place. Here, with the cold weather, I noticed that there was no wind in my legs, since I was basically standing in this position, and the entire flow went to my forehead.
Initially, the information reached such that it is necessary to take off the panel, which means that if you take it off, then glue it, otherwise it will rattle and rattle, as an exception, my panel is virgin, it doesn’t make any noise at all, apparently the assembly of the 9th year mixed with 10 spare parts in total is not only talking about the panel , I noticed that the newer the priors, the less durable they are and the less they crumble. The build quality and spare parts are poor.
I collected information and decided to cut the panel, behind the shield, sinning on the copier, I had already found a textolite to make a new one. And then I realized that the problem was in the gearbox, (the copier turned out to be intact) I replaced it, and nothing happened to my surprise. But the old gearbox was still breathing.
The air flow control unit, there’s nothing else to break, the copier is intact, the gearbox is new...
The price of a new one is 2250 rubles.
Price upon acquaintance with analysis 500
